2/3-way, 2-position Manual/Pilot

Category: .
Manual operation for load lifing and holding with sing-acting cylinders; automatic « dump » for operating hydraulic tools.

Application – Manual operation for load lifting and holding with single-acting cylinders; automatic “dump” for operating hydraulic tools.

Actuation – Flipper lever/pilot oil.

Functions – With lever in closed position, valve will hold the load. When lever is “open”, valve functions as a true automatic “dump” valve.

Used on these pumps – Furnished with pilot lines and adapters for PA55, PA90, PE30, PE55, PE90 and PE120 series. For application on other pumps, consult factory.

NOTE: A Pressure Switch and/or Gauge (Analog or Digital) may be attached to this valve.

CAUTION: To prevent sudden, uncontrolled descent of a load as it is being lowered, use a Load Lowering Valve (No. 9596) or Counter Balance Valve (No. 9720) in conjunction with the directional valve used in your application.

IMPORTANT: When ordering any valve for a PE30 or PG30 series pump, ½” longer mounting screws are required.
For valves 9504, 9584, 9610 and 9610A, order four 12001 cap screws.
For valve 9582, order two 12001 and two 10856 cap screws.

Order No. Cylinder
Application *
Operation Valve Type Volt Advance / Return Advance / Hold Return Posi-Check® Feature Weight (lbs.)
9610A S.A. Manual 2/3-way, 2 Pos. — No Yes No 4.4
* “S.A.” represents single-acting cylinders
2/3-Way/2-Position Manual/Pilot Valve (9610A) – Diagram
Operating Instructions

Related Products

  • full20_31235671x386_Valve9628

    Post-Tensioning Single-Strand

  • full20_28399671x386_9500

    4-Way, 3-Position (Tandem Center) Manual

  • full20_33606Valve9520

    3-way, 3-position Manual

  • full20_33448671x386_9609

    3 Way 4 Position Manual Pressure Compensated Valve